Publicidad
Step 12
Carefully stand your unit upright.
å
Position your unit in its fi nal location. Turn the ADJUSTABLE FOOT (25E)
å
downward until it touches the fl oor.
IMPORTANT: The ADJUSTABLE FOOT should not extend beyond the
å
bottom edges of the LEGS (K and L).
Before fastening the DOOR to your unit, be sure the mounting screw
å
is against the stops as shown in the right diagram. If it isn't, loosen
the mounting screw to slide it against the stops. Then tighten the
mounting screw.
Fasten the DOOR (H) to the RIGHT END (A) as shown in the lower
å
diagram. Use the screws in the HINGES. You should start each SCREW
a few turns before completely tightening any of them.
Fasten a KNOB (69K) to the DOOR (H). Use a GOLD 1"
å
MACHINE SCREW (50S).
Peel two BUMPERS from the BUMPER CARD (29M) and
å
stick them on the DOOR (H) where they will come in
contact with the RIGHT UPRIGHT (C).
Repeat this step for the other DOOR (H).
å
See the next step for DOOR adjustments.
å
L
K
Page 16
A
C
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
GOLD 1" MACHINE SCREW
(2 used for the KNOBS)
29M
H
29M
25E
Turn the ADJUSTABLE FOOT
downward until it touches the fl oor.
50S
69K
Floor
Publicidad
