Using Your Air Crazy™ Hot Air Popcorn Popper - West Bend AIR CRAZY Manual De Instrucciones

Ocultar thumbs Ver también para AIR CRAZY:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

U
SING
This popper uses hot air to pop the corn. DO NOT place anything other
than popcorn kernels into the popping chamber.
1. Remove the cover and measuring/butter cup. Ensure the vents are clear of
popcorn pieces before each use. For a single serving, use the measuring/butter
cup to measure to the line, or use a standard measuring spoon to measure 2
tbsp. For a family serving, use one full scoop of the measuring/butter cup, or use
a standard measuring cup to measure ½ cup of popcorn kernels. DO NOT
attempt to pop more than ⅔ cup of popcorn kernels at one time.
2. Pour popcorn kernels into the popping chamber. DO NOT put oil, butter,
shortening, salt, or anything other than popcorn into the chamber. Place the
cover in position, then place the measuring/butter cup into the cover.
3. If buttered popcorn is desired, place 2-3 tablespoons of room temperature butter,
cut into 4 equally sized pats, into the measuring/butter cup. Note: Do not use
cold butter as it will not melt completely in the short popping cycle. DO NOT
remove the measuring/butter cup during the popping cycle. If unbuttered popcorn
is desired, it is still necessary to place the measuring/butter cup into the cover.
Never run the Air Crazy™ popcorn popper without the cover and
measuring/butter cup in place.
4. Place a 4 quart, or larger, heat-resistant bowl below the popcorn chute to collect
popcorn as it pops. ½ cup of popcorn kernels will yield between 3 and 4 quarts of
popped popcorn. Note: We recommend using a bowl that is at least 5.5" deep
when popping corn.
5. Plug the cord into a 120 volt, AC outlet ONLY. With the cover and
measuring/butter cup in place, press the "ON/OFF" switch to the on position,
toward the " l " symbol.
6. Popcorn will begin to pop, and the cycle will be done within 3 - 4 minutes. After
popcorn has completed popping, turn the "ON/OFF" switch to the off position, the
" O " symbol. Popcorn cycle has completed when there is a gap of 5 seconds
between kernels popping. Unplug the popper from the outlet. Let the popper sit,
with the lid and measuring/butter cup in place, for at least one minute after
completion of the popping cycle. Unpopped kernels may still pop unexpectedly.
Use caution when handling the Air Crazy™ popcorn popper, it will be hot after
popping cycle. Always use hot pads or oven mitts to handle the hot appliance.
7. If butter was melted in the measuring/butter cup, pour over the top of the popped
corn and sprinkle with salt or other popcorn seasonings as desired.
8. If you wish to pop more batches of popcorn immediately, remove any unpopped
kernels and loose popcorn from the popper by inverting the popper. Use oven
mitts or hot pads when handling the hot popper. If butter was melted in the butter
cup, clean and dry the measuring/butter cup and replace in the cover. Repeat
steps 1-7 above.
• A small amount of smoke and/or odor may occur upon heating due to the
release of manufacturing oils – this is normal.
• Some minor expansion/contraction sounds may occur during heating and
cooling – this is normal.
Y
A
C
OUR
IR
RAZY
™ H
A
P
OT
IR
4
P
OPCORN
OPPER

Publicidad

Tabla de contenido
loading

Tabla de contenido