Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

W W A A R R N N I I N N G G
Install a minimum
of 2 main drains
with listed suction
outlet covers.
Each suction outlet cover shall be rated
at/or above the maximum system flow rate.
Pumps can quickly generate strong suction, which poses the risk of
entrapment if improperly connected to the suction outlets. Disembowelment,
entrapment or drowning can occur when body parts or hair come into
contact with damaged, cracked, missing or unsecured drain covers and
suction outlets. Pumps and fittings shall be installed in accordance with
the latest NSPI or IAF standards, CPSC guidelines and national, state and
local codes to minimize this risk. Some of these requirements follow.
Always consult the latest regulations to ensure that your installation meets
the necessary requirements to minimize suction entrapment.
1. All fully submerged suction outlet covers shall be listed according to
the ANSI/ ASME A112.19.8 standard.
2. Do not use a pump in an installation that has only one fully submerged
main suction outlet.
3. If main drains are installed in your pool, there must be a minimum of
two for each pump, and each drain must include a listed suction outlet cover.
VINYL LINER MAIN DRAIN TYPICAL INSTALLATION
(see last page for replacement part Number)
Suction outlet cover
Gasket
Pool Liner
Secondary port,
Plug if not used
RISK OF SUCTION ENTRAPMENT, COULD
RESULT IN SERIOUS INJURY OR DEATH.
Minimum of
apart
3' (0,91 m)
94129432, 94120037, 94120011
MOL215-AV MD-L15-AV MD-L2-AV
Mounting flange
Sand or fill
Plug suction line for
pressure test, then
remove plug
Les Équipements de Piscines Carvin Inc. 
COMPETITION POOL ACCESSORIES INC.
Carvin Pool Equipment Inc.
4000 Boul. Casavant O. St-Hyacinthe,
12775 , rue Brault, Mirabel, Québec, Canada J7J 0C4
(Québec) Canada J2S 9E3
Tél.: (450) 437-2420 Fax: (450) 437-4860 www.competition-pool.com
LES ACCESSOIRES DE PISCINE COMPETITION INC.
Tél : 450-250-4500 : Fax : 450-250-4501
Sans Frais  Toll Free : 1-866-979-4501
http://www.carvinpool.com
Les Équipements de Piscines Carvin Inc. 
VINYL LINER & GUNITE SUCTION OUTLET
(MAIN DRAIN) TYPICAL INSTALLATION
Model Numbers : MD-G15-AV, MD-G2-AV, MD-L15-AV,
Wading pools may have additional requirements to minimize entrapment
hazards.
4. Skimmers may supply 100% of the required flow to the pump, and must
be vented to air.
5. When two suction outlets are used, the maximum system flow rate shall
not exceed the rating of either of the two listed suction outlet covers
installed. When more than two are used, the sum of the ratings shall be at
least twice the maximum system flow rate.
6. Each suction outlet cover shall be separated by a minimum of 3' (0,91 m),
measured from the centre of the suction pipes.
7. Avoid installing check valves. If check valves must be used, ensure that
the installation complies with the applicable standards.
8. Never use the pool or spa if a suction outlet cover is damaged, cracked,
missing or not securely attached. The suction outlet cover must be attached
with stainless steel screws supplied with the cover. If the screws are lost,
order replacement parts from your supplier.
NOTE : For the latest NSPI or IAF standards, contact the Association of Pool
and Spa Professionals (APSP) at www.theapsp.org or (703) 838-0083, ext. 301.
For the latest Consumer Product Safety Commission (CPSC) guidelines,
contact the CPSC at www.cpsc.gov or (301) 504-7923. "Guidelines for
Entrapment Hazards : Making Pools and Spas Safer" can be viewed at
www.cpsc.gov/cpscpub/pubs/363.pdf
GUNITE MAIN DRAIN TYPICAL INSTALLATION
Les Équipements de Piscines Carvin Inc. 
Carvin Pool Equipment Inc.
4000 Boul. Casavant O. St-Hyacinthe,
(Québec) Canada J2S 9E3
Les Équipements de Piscines Carvin Inc. 
MD-L2-AV, MOL215/D and MO215/D
~ Designed for use in multiples
94129433, 94120078, 94120052
MO215-AV
MD-G15-AV MD-G2-AV
Finished pool
floor
Gunite
Reinforcing Bar
221666071496F
M
PO
MA
PO
BO
BO
MA

Publicidad

loading

Resumen de contenidos para Jacuzzi MD-G15-AV

  • Página 1 VINYL LINER & GUNITE SUCTION OUTLET (MAIN DRAIN) TYPICAL INSTALLATION Model Numbers : MD-G15-AV, MD-G2-AV, MD-L15-AV, MD-L2-AV, MOL215/D and MO215/D ~ Designed for use in multiples W W A A R R N N I I N N G G RISK OF SUCTION ENTRAPMENT, COULD RESULT IN SERIOUS INJURY OR DEATH.
  • Página 2 SORTIE DE VIDANGE À ASPIRATION POUR TOILE EN VINYLE OU GUNITE (CONDUITE PRINCIPALE DE DRAINAGE) — INSTALLATION TYPE Numéros de modèles : MD-G15-AV, MD-G2-AV, MD-L15-AV, MD-L2-AV, MOL215/D et MO215/D ~ Conçu pour l’utilisation en multiples RISQUE DE PIÉGEAGE CAUSÉ PAR L’ASPIRATION QUI PEUT ATTENTION ENTRAÎNER DES BLESSURES GRAVES, VOIRE LA MORT.
  • Página 3 INSTALACIÓN TÍPICA DE SALIDA DE SUCCIÓN (DESAGÜE PRINCIPAL) CON SISTEMA DE GUNITADO Y REVESTIMIENTO DE VINILO Número de modelos: MD-G15-AV, MD-G2-AV, MD-L15-AV, MD-L2-AV, MOL215/D y MO215/D ~ Diseñado para usos múltiples RIESGO DE APRISIONAMIENTO POR SUCCIÓN QUE, DE NO EVITARSE, ¡ADVERTENCIA!
  • Página 4 No. Part Number Description 1‐ 14‐2112‐05‐R2 Flat Head Cover screw (2/bag) 2‐ 43‐1128‐04‐K White Cover with screw 3‐ 14‐2029‐07‐R8 Contersink retaining ring Screw (8/bag) 4‐ 43‐1129‐03‐R Retaining Ring 5‐ 13‐1207‐04‐R2 Gasket (2/bag) 6‐ N/A Body No. Part Number Description 1‐ 14‐2638‐20‐R Long Flat Head Cover screw (2/bag) 2‐ 43‐1128‐04‐K White Cover with screw 3‐ N/A Body...

Este manual también es adecuado para:

Md-g2-avMd-l15-avMd-l2-avMol215/dMo215/d