Sunforce 81089 Montaje E Instalación página 3

!
NOTE:
Your utility light must be mounted INDOORS. Your solar panel must be installed outdoors to receive light from the sun.
3
8.5 in (21.6 cm)
Using a measuring tape and pencil, mark two Xs– 8.5 inches
(21.6 cm) apart from each other– on the desired surface.
Optional: Use a power drill (not included)
Drill the holes over the marked Xs on your chosen mounting surface
leaving .25 inches (0.6 cm) of screw sticking out from the wall.
6
Prior to using your solar utility light, the solar panel needs to be connected to the light for a
period of three days. This initial charge should be done in the OFF position. After the third day the
included battery will be fully charged and your utility light is ready for operation. Place the switch
in the AUTO position.
The ON position acts to override the motion activation function. This will allow a limited period of
constant illumination.
4
Slide the utility light's mounting slots (located on the back
of fixture) over the exposed screws to mount it securely to
the wall.
7
ON OFF AUTO
The included battery is located in the battery housing behind the light fixture. Select the OFF position
on the light prior to opening the battery housing. Remove the screws to reveal the rechargeable battery.
Your utility light requires the use of 1 rechargeable lithium-ion battery.
3
5
Connect the wire from the solar panel into the socket located
under the utility light. Your utility light will now begin to charge.