Denver IOB-208 Manual De Instrucciones página 10

Install your camera
Step 1: Please turn the flip switch to "OPEN" and open
the cover, then install the 18650 batteries and
Micro-SD card. (Please make sure that the
polarity of the battery is correct). Long press the
RESET button until you hear the "system reset"
prompt from the camera speaker.
Step 2: Install anchors into a stucco, brick or concrete
surface. Use the drill bit to drill one hole in your
wall and install the anchors. Install the base
bracket on the wall (Picture 1) .
Picture 1
Step 3: Align the device to the base bracket and hold it,
then adjust the appropriate angle, the
installation is finished (Picture 2) .
Notes:
1. The USB interface is only used for power supply.
2. When the mobile phone is connected to the home WiFi
router, the mobile APP can generate a QR code that
includes the name and password of the WiFi router. The
product recognizes the QR code through the lens on the
product, and the product is automatically connected to
the router and server after identification. At this time, the
APP also finds the product through the server, and the APP
can control the operation of the product through the
-8-
network.
Picture 2