Denver ASA-60 Manual De Instrucciones página 4

Installation
- Open the case and remove the battery activation
strip.
- Mount the sensor on the door and the magnet on
the door frame.
-
Make sure the magnet is placed above of the
transmitter.
-
Mount the magnet max. 1cm away from the
transmitter and secure the transmitter and
magnet with double-sided tape or screws.
- Avoid mounting the sensor in areas with a large
amount of metal or electrical wiring, such as a
furnace or utility room.
Register the detector in the alarm system
Switch to Connection Mode on the control panel.
Separate the magnet of the detector from its
transmitter. The control panel beeps once: the
detector is registered. If you hear two beeps, the
detector has already been connected.