Tools You Will Need; Anti-Tip Bracket Installation Instructions Important Safety Warning - Frigidaire FFEH3051VS Instrucciones De Instalación

30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS

2. Tools You Will Need

For leveling legs and Anti-Tip Bracket:
• Adjustable wrench or channel lock pliers
• 5/16" Nutdriver or Flat Head Screwdriver
• Electric Drill & 1/8" Diameter
Drill Bit (Masonry Drill Bit if
installing in concrete)
• Level & Measuring Tape
For electrical supply connection:
• 1/4" & 3/8" Socket driver or Nutdriver
Additional Materials You Will Need:
• Power Supply Cord or
• Copper Electrical Wiring & Metal
Conduit (for hard wiring)
3. Anti-tip Bracket Installation Instructions
Important Safety Warning
To reduce the risk of tipping of the range, the range
must be secured to the fl oor by the properly installed
anti-tip bracket and screws packed with the range.
Failure to install the anti-tip bracket will allow the
range to tip over if excessive weight is placed on an
open door or if child climbs upon it. Serious injury
might result from spilled hot liquids or from the range
itself.
If range is ever moved to a diff erent location, the
anti-tip brackets must also be moved and installed
with the range.
Instructions are provided for installation in wood
or cement fl oor. When fastening to fl oor, be sure
that screws do not penetrate electrical wiring or
plumbing.
Tip Over Hazard
• A child or adult can tip the range
and be killed.
• Verify the anti-tip device has
been installed to fl oor or wall as
per installation instructions.
• Ensure the anti-tip device is re-engaged to fl oor
or wall when the range is moved.
• Do not operate the range without the anti-tip
device in place and engaged.
• Failure to follow these instructions can result in
death or serious burns to children and adults.
Range
Leveling
Leg
To check if the anti-tip bracket is installed
properly, use both arms and grasp the rear edge
of range back. Carefully attempt to tilt range
forward. When properly installed, the range
should not tilt forward.
A. Locate the Bracket Using the Template - Locate
the bracket position (right or left side) by placing
the template symmetrically to the center of the fi nal
range position. Mark the location of the screw holes,
shown on template.
3
Anti-Tip
Bracket
Figure 1