Elkron IT-USB Manual Del Usuario página 3

DESCRIPTION
A PC USB interface is an accessory for connecting the PC to the control unit through the USB port (similarly
with the TTL/RS232 interface that is connected to the RS232 port), for programming by means of the FAST
LINK or HI-CONNECT software.
CONFIGURATION
In order to correctly use the interface, the dip-switches shall be set as indicated in the table below:
Switch Function
1 Monitor LED
2
Selecting the type of control
unit
3 -
4 -
INSTALLATION
Fit the cable running from the IT-USB interface (WITHOUT CONNECTING THE LATTER TO THE
•
CONTROL UNIT) into the computer USB port. Wait for Windows
peripheral unit. Select, when the driver requests so, the USB_FDTI
release 3.00 and following) or select the IT USB Driver folder from the HI-CONNECT CD, then complete
the installation.
Warning! Make sure that the address assigned by Windows
•
range of COM1 to COM4 (see next paragraph).
Then fit the interface comb-shaped connector onto the control unit (see figure).
•
Remove the interface after use.
•
WARNING: carry out connection and disconnection with the control unit OFF.
SETTING THE COMMUNICATION PORT ADDRESS
Valid for FAST LINK SW only
®
Windows 98:
Path: File manager
Select Port settings, then click on Advanced. Then select a free COM port number (1 to 4) from the drop-
down menu.
®
Windows 2000/XP:
Path: File manager
Select Port settings, then click on Advanced. Then select a free COM port number (1 to 4) from the drop-
down menu.
FAST LINK:
Select Actions Archives
4) from the drop-down menu.
SPECIFICATIONS
Rated supply voltage Vdc – from the PC................................................................. 5 V―
Rated absorption Icc – from the PC ........................................................................ 25 mA
Standard .................................................................................................................. USB 1.1 - 2.0 compatible
Operating temperature............................................................................................. 0 ÷ 45°C
Warehousing temperature ....................................................................................... –20 ÷ 70°C
Description
When set to ON, it makes the LEDs to blink during
communication between the PC and the control unit
OFF = Use with wireless control units WL30,WL31
ON = Use with control units MP106, MP110, MP120,MP508TG
Always leave set to OFF
Always leave set to OFF
Control panel System
Control panel System
Configuration
Peripheral control
Hardware Peripheral control
Modem Bus configuration: select a COM port number (1 to
3
®
to detect the presence of the
®
folder from the FAST LINK CD (only
®
to the USB port falls within the
Ports Properties
Ports
GB
IT-USB