Publicidad
Step 7
Separate the EXTENSION SLIDES (W) from the EXTENSION RAILS (V) as shown in the enlarged diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (V) to the ENDS (A and B) and UPRIGHTS (C and D). Use eight GOLD 5/16" FLAT
å
HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge
å
of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
Push the black lever in and pull the SLIDE from the RAIL.
V
Open end
Open end
www.sauder.com/services
W
A
B
LEFT END ASSEMBLY
C
V
Open end
V
RIGHT END ASSEMBLY
Open end
V
D
418072
V
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
3S
Page 11
Publicidad
