Kohler R706534-8L-SHP Guia De Instalacion página 30

Troubleshooting (cont.)
Troubleshooting Table
Symptoms
5. Water leaks.
6. The wall jamb cannot be
installed under the
header.
1380408-2-B
Probable Cause
B. The centerguide clip is not
installed.
C. The screw connecting the
centerguide clip is loose.
D. The film on the adhesive on the
bottom of the centerguide was
not removed.
A. Water leaks under the threshold. A. Apply 100% silicone sealant to the
B. Water leaks under a door panel.
C. Water leaks under a door panel.
D. Water leaks between the door
panels.
E. Water leaks around the wall
jamb.
F. Water leaks at the bottom of the
wall jamb and over the
threshold.
A. The bracket is installed too low.
30
Recommended Action
B. Remove the outside header and
both door panels. Install the clip,
then install the centerguide over
the clip. Reinstall the panels and
outside header.
C. Remove the outside header and
both door panels. Tighten the clip
screw. If the screw does not
tighten, drill a new hole close to
the original hole. Install the
centerguide over the clip. Reinstall
the panels and outside header.
D. Remove the outside header and
both door panels. Lift the
centerguide off the clip, remove the
film on the tape and reinstall the
centerguide over the clip. Reinstall
the panels and outside header.
outside edge of the threshold. See
the sealant manufacturer's
instructions before using the
shower.
B. Adjust the rollers to lower the door
panels closer to the shower ledge.
Refer to the "Adjust the Door
Panels" section.
C. Check the height of the header. The
header should sit on top of the
wall jambs.
D. When showering, make sure the
inside panel is closest to the
showerhead.
E. Adjust the door panel so the panel
touches both the top and bottom
bumpers. Try not to spray water
directly onto the door panels.
F. If there is a gap between the
bottom of the wall jamb seal and
the top of the threshold, silicone
this area.
A. Adjust the bracket higher by
loosening the screws and pushing
upward on the bracket.
Kohler Co.