Carro de acero, ajustable para un proyector (7 páginas)
Resumen de contenidos para LDI Spaces SAFCO 3671
Página 1
ASSEMBLY INSTRUCTIONS INSTRUCTIONS DE MONTAGE an LDI Spaces Company Minneapolis, MN 55428 INSTRUCCIONES DE ENSAMBLAJE www.safcoproducts.com 3671 Low-Profile 58” Desk Topper with Top Étagère de petit profi l avec panneau supérieur, 147 cm El estante del pequeño-perfi l con el tablero superior, 58”...
Página 2
TOOLS REQUIRED: Short Flat-Blade and Phillips Screwdrivers OUTILS NÉCESSAIRE : Court Tournevis avec Lame Plate et Court Tournevis Phillips HERRAMIENTAS REQUERIDAS: Destornillador corto con la pala llana y el destornillador corto de Phillips Parts List / Liste des Pièces / Lista de Piezas §Note: When corresponding about parts, be sure to state color: Gray (GR), Mahogany (MH),...
Página 3
3671-37MP: 3 of 8; Rev. 3; 3/10 Safco Products Company, New Hope, MN 55428...
Página 4
Determine whether the small shelf section of the unit should be at the left or right side, and screw a short screw post into the appropriate (left or right) small hole near the bottom edge of the back panel. Déterminez si la petite section de l’étagère de l’unité devrait être à la gauche ou côté...
Página 5
Note: the upper cam on the inner leg panel is used only to fill the hole; it does not engage a screw post. Note : la came supérieure sur le panneau de la jambe intérieur est utilisée pour remplir le trou seulement ; il ne connecte pas de poteau.
Slide the (left or right) side panel onto the end of the shelf and back assembly farthest from the inner leg panel. Fasten by turning the cams clockwise, as before. Carefully set the unit upright. Glissez le panneau latéral ( gauche ou droit ) sur la fin de l’étagère et en arrière assemblée.
Página 7
Use a short handled screwdriver to fasten the cams on the underside of the top panel (just this end) by turning them clockwise as far as they will go. Utilisez un court tournevis manié pour attacher les cames sur le dessous du panneau supérieur (seulement cette fin) en les tournant comme les aiguilles d’une montre jusqu’à...
Página 8
Cover upper exposed holes or cams with adhesive covers. Couvrons les trous supérieur exposé ou cames de couvertures adhésives . Cubre los agujeros expuestos superiores o las levas de freno con cubiertas adhesivas. 3671-37MP: 8 of 8; Rev. 3; 3/10 Safco Products Company, New Hope, MN 55428...