myTouchSmart 46228 Montaje & Instalación

Outdoor Digital
Simple
Plug-In Timer
Mounting /Installation
1. Mount the timer on a wall near a GFCI receptacle using a screw or nail. Install timer as far above ground level as possible with
receptacle facing downward. Do not install where timer can be immersed or where water will splash or drip onto receptacle.
Screw or nail head must extend at least 3/16" out from the wall (nail or screw not included).
2. Hang the timer from the hole at the top of the unit.
Setup
The timer's built-in sensor will automatically turn on at dusk and off 6 hours later.
1. To test product, plug in and cover sensor. The light will trigger immediately and stay on for 6 hours. This test mode is only
available for the first time after being plugged in. Timer will have a 30-second delay after initial test mode.
NOTE: To ensure proper operation of the automatic function, ensure the photocell sensor is shielded from all night time sources of light,
such as floodlights. Also ensure the photocell sensor has direct access to sunlight
NOTE: Timer must sense light for at least 30 seconds before it will turn on again after sensing darkness.
MADE IN CHINA
Distributed by Jasco Products Company LLC,
10 E. Memorial Rd., Oklahoma City, OK 73114.
This Jasco product comes with a 1-year limited warranty.
Visit www.byjasco.com for warranty details.
Questions? Contact us at 1-800-654-8483 between 7:00AM–8:00PM CST.
WARNING
RISK OF ELECTRIC SHOCK
RISK OF FIRE
• PLUG DIRECTLY INTO • DO NOT USE TO CONTROL
A GFCI PROTECTED APPLIANCES THAT CONTAIN
ELECTRICAL OUTLET
HEATING ELEMENTS (COOKING
• UNPLUG TIMER APPLIANCES, HEATERS,
BEFORE CLEANING IRONS, ETC.)
• FULLY INSERT PLUG • DO NOT EXCEED
• KEEP AWAY FROM CHILDREN
ELECTRICAL RATINGS
• NOT FOR WATER IMMERSION • DO NOT USE IF DEVICE
• SUITABLE FOR INDOOR OR CORD IS DAMAGED.
AND OUTDOOR LOCATIONS, • DO NOT USE WITH AN
STORE INDOORS WHILE
EXTENSION CORD
NOT IN USE.
This device complies with part 15 of the FCC and Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1 this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
FCC NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
Ratings:
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
125V 50/60Hz
frequency energy and, if not installed and used in accordance with the instructions may cause harmful
Max. Load:
interference to radio communications. However, there is no guarantee that interference will not occur in a
10A 1250W General
particular installation. If this equipment does cause harmful interference to radio or television reception, which
Purpose/Resistive
can be determined by turning the equipment off and on, the user is encourage to try to correct the interference
5A 625W Tungsten
by one or more of the following measures:
1/4HP Type 3R
• Reorient or relocate the receiving antenna.
Works with dimmable
• Increase the separation between the equipment and receiver.
LED and CFL bulbs.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
GE53126 CAN ICES-3(B)/NMB-3(B)