Audio Playback; Care And Maintenance; Troubleshooting - Scosche SPORTCLIP AIRHFBT300 Manual Del Usuario

AUDIO PLAYBACK

Function Headset Status
Playing audio
Volume up
Playing audio
Volume down
Next track
Playing audio
Previous track
Playing audio
Pause Playing audio
Audio paused
Play
• When the volume is adjusted to maximum level you will hear " maximum volume". When the
volume is adjusted to minimum level, you will hear a low prompt tone.
• To use the remote control's lasVnext song, pause/play functions, the B/uetooth mobile phone or
B/uetooth transmitter paired with the headset must support AVRCP profile. Please refer to the
user manual for your mobile phone or B/uetooth transmitter for further information.

CARE AND MAINTENANCE

• Keep headset dry. Avoid exposure to direct sunlight, and extreme heat or cold.
• Do not attempt to disassemble the product.
• Avoid dropping or exposing to hard impact.
• Do not use intensive chemical products or detergent to clean the product.
• Do not scratch the surface with sharp objects.
• Do not submerge headset
Problem
LED flashes red instead of blue
LED does not flash red while
charging.
No sound
Sound is unclear
Buttons on remote do not work
during audio playback
LISTENING TO MUSIC AT EXCESSIVE VOLUME CAN RESULT IN PERMANENT HEARING DAMAGE.
WARNING:
1. Make sure volume is lowered before wearing headset. Hearing damage may occur from listening at high volume or
sustained listening at unsafe volume levels.
2. Ringing in the ears may indicate that the volume level is too high. We recommend lowering the volume.
3. Do not use while driving, cycling, operating machinery, or in any manner that may impair awareness of your surroundings.
4. If you are using the headphones with an airplane's sound system, we recommend lowering the volume level so that
the pilots' messages do not cause discomfort to your ears.
5. Have your ears checked by an audiologist regularly. If you are experiencing wax build up, stop using the headphones
until an audiologist has examined your ears.
6. Stop using the headphones if they begin to cause great discomfort or infection.
Quickly press"+" button. Repeat to reach desired volume
Quickly press"-" button. Repeat to reach desired volume
Press and hold"+" button
Press and hold "-" button
Quickly press MFB once
Quickly press MFB once

TROUBLESHOOTING

Solution
Charge battery
Check charge cable connection.
Battery may be drained to the point that charging does not register
immediately. Allow up to 30 min. for light to come on
Make sure headset is turned on.
Make sure volume is not muted or too low.
Make sure headset is connected to phone correctly.
Make sure headset is with range of phone.
Check cellphone reception
Make sure headset is with range of phone.
Make sure phone supports AVRCP (Audio/
Video Remote Control profile)
FETY PRECAUTIONS
5
Operation