Replace Battery - Trust ZIGBEE ZSDR-850 Instrucciones De Instalación

EN ZSDR-850 ZIGBEE SMOKE DETECTOR
Activate connect mode: After
resetting the detector you can
activate the connect mode by
pressing the button in the
hole on the side for approx.
2 sec. The LED will flash fast
for 1 minute to indicate the
connection mode.

REPLACE BATTERY

A
Open the battery
compartment by removing
the detector from the
bracket.
B
Remove the empty battery
and insert a new 3V
CR123A lithium battery in
the compartment. Note
the positive and negative
polarity.
C
Lock the detector back
on the bracket. Test if the
battery is placed correctly
10
by activating the test mode.
(See step 6).
DISCLAIMER
This product is used as a
warning device to aid the user
in detecting for the presence
of smoke. However, it remains
the responsibility of the end-
user to prevent, detect and/or
extinguish a (smoldering) fire
or smoke from accumulating.
Therefore Trust cannot be held
responsible or liable for any
damages or injuries resulting
from fire, smoke or heat or any
subsequent damages.
ZSDR-850 ZIGBEE SMOKE DETECTOR EN
11