Back Panel; Connecting The Cables; Wan Port; Lan Port(S) - Conceptronic C150BRS4 Manual De Instrucciones

ENGLISH

2.2 Back panel

1
Nr Description
1 Wireless antennas (2x)
2 Radio ON/OFF switch
3 Reset/WPS button
4 LAN ports (1 – 4)
5

WAN port

6 Power connection
Connect the power supply to the power connection on the back of the C150BRS4 and to an available wall
socket. The power LED on the front of the C150BRS4 will lit up.
3.1 WAN port
Use a network (LAN) cable to connect the C150BRS4 to your broadband modem.
The WAN LED on the front of the C150BRS4 will lit up.
Note: If the WAN LED on the front does not lit up, make sure that:
- The C150BRS4 is powered on (the power LED should burn).
- The broadband modem is turned on.
- The network (LAN) cable between both devices is connected correctly.

3.2 LAN port(s)

Connect the network (LAN) cable to 1 of the 4 LAN ports on the back panel of the C150BRS4 and to the
network card of your computer.
The LAN LED of the used LAN port will lit up, indicating that the computer is connected. (Your computer
must be switched on and the LAN connection must be enabled).
28
2 3 4
Explanation
Two fixed antennas for wireless broadcasting
Turn the wireless radio on or off
Activate WPS function (short press) or perform a reset (hold)
Connect your computer(s)/network device(s) to the router
Connect your broadband connection to the router
Connect the power supply to the router

3. Connecting the cables

5 6 1