Operation
1
Flushing and checking for leaks
□
Ensure the faucet handles are in the off position,
and turn on the water supply and check for leaks.
If you discover any leaks, check your connections
to ensure they are installed properly.
□
Turn on the hot and cold handles to allow the
water to run for at least one minute. This
ushes away any debris that could cause
damage to internal parts.
□
Rotate the diverter handle (P) 180°
counter-clockwise to make the diverter
handle (P) is facing backward, and allow
both hot and cold water to run for at least
one minute each from the
This ushes away any debris that could cause
damage to internal parts.
□
While the water is running, check for leaks.
□
Turn off the water.
Care and Cleaning
□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Troubleshooting
NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
There are leaks from the
handle.
The water will not shut off
completely.
spray assembly
(Z).
Possible Cause
The bonnet nut has come loose and/or the
washer is dirty or damaged.
The cartridge is dirty or broken.
□
□
□
□
9
Please contact 1-877-580-5682 for further assistance.
A
P
Z
Solution
Tighten the bonnet nut.
Clean or replace the washer.
Remove the handle to check
the cartridge.
Clean or replace.
WWW.HOMEDEPOT.COM/PEGASUS