5. Clean the blade and the underside of the device us-
ing a brush.
Illustration V
Removing blockages
WARNING
Removing blockages
Incision injuries from the sharp blade or sharp-edged
objects
Wear protective gloves when checking for blockages or
removing blockages.
1. Switch the device off and wait until the blade comes
to a standstill.
2. Remove the safety key.
3. Remove the battery pack (see Chapter Removing
the battery pack).
4. Remove the grass catcher and check for blockages.
Remove any blockages.
5. Check the ejection shaft for blockages. Remove any
blockages.
6. Tip the device onto the side.
7. Check the underside of the device and the blade for
blockages. Be careful when removing blockages be-
cause the blade can move while doing this.
Replacing the blade
1. Remove the safety key.
2. Remove the battery pack (see Chapter Removing
the battery pack).
3. Clean the underside of the device (see Chapter
Cleaning the device).
4. Lock the blade and then loosen the screw.
Illustration W
5. Remove and dispose of the blade.
Illustration X
6. Fit the new blade into the holder.
Illustration Y
7. Lock the blade and then tighten the screw.
Illustration Z
Troubleshooting guide
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
The device switches off
The device overload protection system has triggered.
1. Release the ON/OFF switch.
2. Press the start button and the ON/OFF switch.
The battery pack overheating protection has triggered.
1. Wait until the battery pack temperature lies within
the normal range.
2. Charge the battery pack if the device cannot be
switched on.
Technical data
Device performance data
Nominal voltage
Cutting width
Cutting height
Grass catcher volume
Idle speed
Determined values in acc. with EN 60335-2-77
Sound pressure level L
pA
22
V
36
cm
40
mm
20-70
l
50
/min
3550 ±
10%
dB(A)
80,1
English
Uncertainty K
pA
Sound power level L
+ K uncer-
WA
tainty
WA
Right handle hand-arm vibration
value
Left handle hand-arm vibration
value
Uncertainty K
Dimensions and weights
Length x width x height
Weight (without battery pack)
Subject to technical modifications.
Warranty
The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
EU Declaration of Conformity
We hereby declare that the machine described below
complies with the relevant basic safety and health re-
quirements in the EU Directives, both in its basic design
and construction as well as in the version placed in cir-
culation by us. This declaration is invalidated by any
changes made to the machine that are not approved by
us.
Product: Battery-operated lawnmower
Type: LMO 36-40 Battery: 1.444-45x.x
Currently applicable EU Directives
2000/14/EC (+2005/88/EC)
2014/30/EU
2006/42/EC (+2009/127/EC)
2011/65/EU
Harmonised standards used
EN 50581: 2012
EN 55014-1: 2017
EN 55014-2: 2015
EN 60335-1:2012+A11:2014+A13:2017
EN 60335-2-77:2010
EN 62233: 2008
Conformity evaluation procedure used
2000/14/EC and amended by 2005/88/EC: Annex VI
Sound power level dB(A)
Measured: 91,4
Guaranteed: 94
Name and address of the notified body involved
Société Nationale de Certification et d'Homologation
2a. Kalchesbruck
L-1852 Luxembourg
ID no. 0499
The signatories act on behalf of and with the authority of
the company management.
dB(A)
2,5
dB(A)
94
2
m/s
1,5
2
m/s
1,2
2
m/s
1,5
mm
1300 x
433 x
995
kg
18,5