Changing The Bulb; Care And Cleaning - Hydrofarm Jump Start JSFC2KT Instrucciones

4. Insert the power cord into the light system.
The system is now ready to use.
Fig. 4
5. The direction of the light can be adjusted
according to your needs (see Fig. 5).
Fig. 5

CHANGING THE BULB

1. If using the Modular T5 Dock, detach the
strips from the dock before replacing the
tubes.
2. Rotate tube clockwise to loosen and lift from
sockets.
3. Insert replacement tube and rotate
counterclockwise to secure in sockets.

CARE AND CLEANING

1. Unplug the T5 and allow to cool.
2. Remove the tube and set aside.
3. Mix warm water and mild soap and apply
sparingly to the strips and reflectors with a
clean washcloth. Dry system with a second
washcloth.
4. Run a dry, soft washcloth over bulbs to
remove dust particles.
5. Place tube back into the reflector.
6. Plug in the power cord.
INSTRUCTIONS
7. DO NOT immerse the system in water.
8. DO NOT use gasoline, paint thinner or other
chemicals to clean the system.
3