RCA RCR450C Manual Del Usuario página 6

Programming Methods (continued)

CR450_NA_IB_02.indd 6
LED
LED
LED
LED
To exit without saving
!
TIP:
at any point in the Manual Code
Search, press and release the
GO BACK key .
1 . Manually turn on the component
you want the remote to control
(TV, VCR, DVD, satellite receiver
or cable box) .
Note: If you press an invalid key
during the Manual Code Search,
the remote does not respond
and the LED indicator light does
not blink . If you do not press
a valid Manual Code Search
key (TV, VCR, DVD, SAT·CBL,
ON·OFF, GO BACK), the search
times out after two minutes .
When the search times out, the
LED indicator light blinks four
times and turns off . The last
programmed code under that
component key is retained .
2 . Press and hold the component key
(TV, VCR, DVD, SAT·CBL) you
wish to program . The LED indicator
light turns on and remains on .
3 . While holding the component
key down, press and hold the
ON·OFF key . The LED indicator
light turns off .
4 . After holding down both keys
for three seconds, the LED
indicator light turns back on .
5 . Release both keys . The LED
indicator light remains on .
Throughout the
!
TIP:
programming of each key, be sure
to keep the remote pointed at the
IR sensor of the component you
are currently programming the
remote to control .
6 . Press and release the ON·OFF key
repeatedly until your component
turns off . Each time you press the
ON·OFF key, the LED indicator
light blinks, and the next code
in the list is sent . This process
continues until all of the codes in
the Code Lists have been searched .
If your component turns off, you
have found the correct code . (If
it cycles through and the LED
indicator light blinks four times
and turns off, all codes have been
searched . The Manual Code Search
method is exited .)
1/30/07 1:01:29 PM