Black and Decker BDH5000 Manual Del Usuario página 6

G
Su Mo
SET
CLK
1
2
SETTING TIMER TO AUTO CLEAN
(FIGURE A, F, H)
Setting the timer will allow your vacuum
to automatically clean at a specific time.
1. Ensure the auto clean function is
deactivated. The "Go" icon (39) should
be turned off.
2. Press the timer button (33). The hour
digits (36) on the LED screen (22)
will blink and the timer icon (40) will
display. Press the + or - buttons
(34 and 35) to set the desired hour
of cleaning.
3. Press the timer button a second time.
The minute digits (37) will blink. Press
the + or - buttons to set the desired
minute of cleaning.
3. Press the timer button a third time. The
LED screen will display "OFF."
4. Press the + button (34) to switch to "ON."
The "1" under the timer icon will switch
to "2".
5. Press the timer button again to exit
timer set up.
H
Su Mo Tu We Th Fr Sa
SET
CLK
1
2
NOTE: In order for the vacuum to start
cleaning at the set time, it must be
charged via the charging dock (21) and
turned on.
NOTE: During auto cleaning and schedule
setting, the vacuum needs to be turned on
and properly connected to the charging
dock (21), otherwise the setting will
be deactivated.
NOTE: If the battery is not fully charged
or has been charging for less than 5
hours, the timer function will not be
activated.
NOTE: If the charging dock (21) loses
power, the clock and timer will need to
be reset.
39
Tu We Th Fr Sa
09:24
GO
40
09:24
GO
HANDLE
The vacuum is equipped with a handle to
make carrying it easy and clean.
Maintenance
WARNING:
is completely dry before using it.
• Use only mild soap and damp cloth to
clean the vac. Never let any liquid get
inside the vac; never immerse any part
of the vac into a liquid.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment (other than those listed
in this manual) should be performed by
authorized service centers or other qualified
service organizations, always using identical
replacement parts.
EMPTYING THE DUST BIN (FIGURE A, I)
1. Turn the power switch (11) off.
2. Press the dust bin release button (41)
and slide the dust bin (9) out of the
vacuum.
3. Empty the contents of the dust bin.
4. Replace the dust bin. Slide it back
onto the vacuum until it clicks firmly
into place.
I
CLEANING THE INLET AND FAN COVER
(FIGURE A, J)
1. Turn the power switch (11) off.
2. Place the vacuum upside down on a
flat surface.
3. Push in the tab (42) on the fan cover
(10) and remove the cover.
4. Clean out debris with the maintenance
brush (26). This will ensure better air
ventilation.
5. Replace cover. Align the nubs
at the ends of the cover before
pressing down.
6
Make sure the vacuum
41