Publicidad
BCM Fog Light Configuration
Vehicle VIN must be updated with the sales code of the added accessory in order to enable system
functionality. Using the DealerCONNECT website and the scan tool, complete the procedure below:
1. Log on to: https://dealerconnect.chrysler.com
2. In the service tab, inside the Warranty Administration box, locate “Vehicle Option Updates.”
Enter the vehicle VIN and add the sales code “LNJ” (fog light) as a “Dealer Installed Option”.
3. Confirm that the new sales code has been successfully added to the VIN.
With the scan tool connected to both the internet (via Ethernet port or wireless connection) and
the vehicle, follow the steps below:
4. Using the scan tool select the VEHICLE PREPARATION and then select RESTORE VEHICLE
CONFIGURATION.
5. Follow the step by step instructions on the scan tool to complete the fog light installation
Fog Light Alignment
The fog lamp adjustment screw is accessed through clearance holes near the right and left outboard ends of the
belly pan below the front fascia. A properly aimed front fog lamp will project a pattern on the alignment screen
100mm (4 inches) below the fog lamp centerline and straight ahead of the lamp.
1) Turn the fog lamps ON.
2) Rotate the fog lamp vertical adjustment screw on each lamp to adjust the beam height as required.
34
6-24-14
REVERSE STEPS 5 THROUGH 10 TO REASSEMBLE ALL
TRIM PANELS AND VEHICLE COMPONENTS
www.mopar.com
8
K6862137
Publicidad
