Preparation; Wiring Diagram - Hoover 7121-01 Manual Del Usuario

Baño del ventilador con luz
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents. If any part is missing or damaged, do not attempt to assemble
the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 minutes
Tools Required for Assembly (not included): Hammer, Flathead Screwdriver, Wire Nuts, Nails, Duct Tape,
Phillips Head Screwdriver, Utility Knife
Helpful Tools (not included): Electric Drill, Drill Bits
WARNING: Turn off electricity at breaker box before beginning installation.
Carefully remove unit from carton.
Check area above installation location to be sure that wiring can run to the planned location and that
duct work can be run and the area is sufficient for proper ventilation.
Inspect duct work and wiring before proceeding with installation.
Before installation, provide inspection and future maintenance access at a location that will not interfere
with installation work.
You may need the help of a second person to install this fan; one person on the attic side and one on
the room side.
Note: Installations may vary depending on how the previous bath fan was installed. Supplies necessary
for the installation of your bath fan are not all included; however, most are available at your local
home improvement or hardware store.
DIMENSIONS REQUIREMENTS
Ceiling
Opening (L)
Opening (W)
7-11/16 in.

WIRING DIAGRAM

Capacitor
for long
motor
life of
motor
www.homewerksww.com
Ceiling
Ceiling
Opening (H)
7-1/2 in.
3-3/4 in.
black
white
green
FAN HOUSING
to 120V AC 60Hz
to switch
to neutral
to ground
Junction box
5

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido