Vornadobaby Sensa Manual Del Propietário página 4

overheating of the outlet may occur even if it has not occurred
with the other appliances.
- This heater is for use with 120 volt electrical outlets. The cord
has a plug as shown at A in Figure 65.1, below. An adapter as
shown at C is available for connecting three-blade grounding-
type plugs to two-slot receptacles. The green grounding
lug extending from the adapter must be connected to a
permanent ground such as a properly grounded outlet box.
The adapter should not be used if a three-slot grounded
receptacle is available.
Adapter
Metal Screw
Grounding
Cover of Grounded Means
(C)
Grounding
Outlet Box
Pin
(B)
(A)
Figure 65.1
- Before moving, repositioning, servicing, cleaning and when
not in use, use the product controls to turn off the power and
then unplug. To disconnect from outlet, grasp and pull only
the plug. Also, power off and unplug if the product will be left
unattended for an extended period of time or during electrical
storms.
- If your heater suddenly stops working:
• This heater is equipped with a thermal cutout safety feature
designed to automatically shut off when overheating is
detected. See the "RESET HEATER" instructions in this guide
to determine how to check and reset the heater.
• If the heater and other electrical products suddenly stop
working at the same time, your home circuit breaker
6 English
or fuse may have tripped due to an overload of power.
Consider only running your heater on the "low" setting,
only running one heater at once and unplugging all other
electrical products while running the heater, and/or hiring
an electrician to install an additional circuit to your home's
electrical system.
SERVICING WARNING — To reduce risk of fire, electrical shock
and injury to persons, observe the following:
- Clean your product regularly, only as is instructed in this
manual. Prior to cleaning, turn off the power on your product
and unplug. Do not use gasoline, thinners, solvents, ammonias
or other chemicals for cleaning. Refer to the CLEANING
instructions provided.
- Do not open appliance housing while product is plugged in.
To avoid risk of shock, all service and/or repairs must be done
by a Vornado Authorized Service Center.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Contact Customer Service or dealer or an experienced radio/TV
technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Supplier's FCC Declaration of Conformity
Unique Identifier: Vornadobaby Model Sensa
Responsible Party: Vornado Air LLC
Mailing Address : 415 E. 13th St., Andover, KS 67002
Contact: www.sihomecomfort.com
This device contains license-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development
Canada's license-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including
interference that may cause undesired operation of the device.
RF Exposure Statement: This product complies with the
FCC and IC RF exposure limit set forth for an uncontrolled
environment and is safe for intended operation as described in
this manual.
WARNING: Batteries may pose a choking hazard. Do not let
children handle batteries.
BATTERY DISPOSAL: Please dispose of batteries according to
the local laws and regulations of your region, and while keeping
them away from children. Some batteries may be recycled and
accepted for disposal at your local recycling center. DO NOT
DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY EXPLODE
OR LEAK. New and used batteries may cause injury. Keep new
and used cells (or batteries) away from children.
SAVE THESE INSTRUCTIONS
English 7