Installation Instructions - e-conolight E-BBD Serie Instrucciones De Instalación

INSTALLATION INSTRUCTIONS

E-BBD Series
FIGURE 2
Make electrical connections above
Wire-Tie
wire-tie, and then tighten in place
Bracket
FIGURE 3
Wire-Tie
Bracket
Base Plate
(4) Hex Head
Socket Screw
Wiring
Conduit
(By Others)
FIGURE 4
(3) Sets of Locking
Washers & Nuts
(3) Sets of
Leveling Washers
Concrete
Foundation
(3) Anchor J-Bolts
(4) Set Screws
www.e-conolight.com |
Document: LPN00585X0001A0_A
Created By:
TMT
ELECTRICAL CONNECTIONS
Fixture is equipped with universal volt driver 120-277V
(ie. 120V, 208V, 240V or 277V)
PHASE TO NEUTRAL WIRING 120/277V
1. Connect supply ground to fixture ground (green) lead.
2. Connect supply common to fixture neutral (white) lead.
3. Connect supply Vin to fixture hot (black) lead.
Tuck all wires carefully into wiring chamber ensuring that no
wires are pinched.
PHASE TO PHASE WIRING 208/240V
1. Connect supply ground to fixture ground (green) lead.
2. Connect supply L1 (Hot) to fixture neutral (white) lead.
3. Connect supply L2 (Hot) to fixture hot (black) lead.
Tuck all wires carefully into wiring chamber ensuring that no
wires are pinched.
CAUTION: Changes or modifications not expressly approved could void
your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
CAN ICES-005 (A)/NMB-005 (A)
888.243.9445 | FAX: 262.504.5409
Date
ECO#
009012
FCC NOTICE
2018-04-02