Instructions For Assembly - Sonia Girta Next HZ-3872 Manual De Instrucciones

SKETCH AND DIMENSIONS

INSTRUCTIONS FOR ASSEMBLY

● Unscrew the clamping knob and insert the headrest
into the backrest of the main body of the bed. Adjust
the headrest to the desired height and turn the knob
clockwise.
● Put the armrest in a more or less vertical position, and
insert it into the internal pin on the backrest of the main
body of the bed. Find the exact position so that the arm
connects perfectly and can be coupled correctly.
● Turn the armrest 90° anticlockwise by placing it
horizontally.
● Perform the same procedure on the 2 armrests.
OPERATION
● Connect the bed to an electrical outlet using the power
cord.
● Turn the ON/OFF switch on the back of the bed to ON. The
bed will then be ready for operation via the integrated foot
control.
ON/OFF switch
● Hand controller
3
5
7
9
11
- Press the button
to activate the control knob. The red
1
indicator will light up and all its functions can be used.
- Press the button again and the red indicator will
1
turn off at the same time as the bed adopts the "chair"
position for the user's comfort.
- While the bed is moving towards the "chair" position,
press the button again or any button on the
1
integrated foot control and the bed will stop at the
position at that time.
- Press the buttons
-
2
5 factory-stored positions.
- Press the button
7 repeatedly to change the colour
of the LED lights on the base. After five presses, it will
enter cyclic colour mode, and with one more press it will
turn off.
- Press the button
8 to adjust the power of the LED
lights on the base. Pressing repeatedly will decrease the
brightness until reaching a minimum level, after which it
will begin to increase again.
- Press the button
10 to inflate the back cushions.
- Press the button
to remove air from the backrest
9
cushions.
1
2
4
6
8
10
12
to place the bed in one of the
6
EN
3