EDM 03226 Instrucciones Importantes De Seguridad página 9

03226
REF.
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
CONNECTION
Time testing
The LED indicator inside the sensor will flash to display the preset times as following:
1. 1 hour: flash one time
2. 2 hours: flash two times
3. 3 hours: flash three times
4. 4 hours: flash four times
5. 5 hours: flash five times
6. 6 hours: flash six times
7. 7 hours: flash seven times
8. 8 hours: flash eight times
9. 9 hours: flash nine times
10. dusk to dawn: rapidly flash ten times
TEST
- Set the LUX knob to "3" position and set time knob to "1h"position.
- When you test in daytime. you should cover a black opaque cloth on the product, after 1 minute, the lamp
will be turned on
- When the cloth mantles the detection window of the photocell, the ambient light of the photocell is less
than 3 LUX, the lamp will be on for one hour.
- When you take away this cloth, the lamp will be off automatically.
- When you slide the LUX knob to "500" position, the lamp could be on in the ambient light less than
500LUX.
NOTE
- In front of the photocell, there should be no obstruction affecting to accept natural light;
- In front of the photocell, there should be no swaying object.
- Don't install the photocell under the light or in the place where the light will be irradiated to the
photocell.
- When lamp is on, another light source irradiate to the photocell, and this light lasts for more than
one minute, the lamp will turn off and the electronic TIMER will stop counting. The TIMER will
recount from the beginning when the light turns on again
- The electronic TIMER will reset when the power is off over 2~5 seconds.
INSTRUCCIONES IMPORTANTES DE SEGURIDAD
-9-