Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4. adjust sensor. For proper operation, the sensor
head must be rotated so that the sensor controls face
downward as shown below.
IMPORTANT: the controls must face downward to
avoid damage from rain. If controls face upward, move
sensor to the original down position, rotate 180°, then
raise to the position shown below.
Light Joint Clamps
Battery Case
Sensor Joint
Clamp
5. Plug the solar panel cable into the bottom of the battery
case. IMPORTANT: allow the battery to charge
with 3 to 7 days of full sunshine before testing. to
verify battery is charged, slide the On-tIMe switch
to teSt. Wait 2 minutes for sensor to warm up.
If light comes on when motion is detected after
warm up period, battery is charged and ready for
use. If light does not come on, slide the On-tIMe
to OFF. recheck the light the next day.
598-1344-03
Light
Sensor
Lens Removal
Tab
Controls
teSt anD aDJuStMent
NOTE: Sensor has a 2 minute warm up period before
it will detect motion. When switching modes wait 2
minutes.
1. Slide the sensor switch to the TEST position.
2. Place the RANGE adjustment in the medium position
(halfway between MIN and MAX position).
Bottom of Sensor
3. Loosen the clamp screw in the sensor ball joint.
Clamp Screw
4. Walk through the coverage area noting when the lights
turn on. Gently move the sensor head up, down, or
sideways to change the coverage area. Note: Wait 5
to 10 seconds after light turns off to retest.
Aim Sensor Down for
Short Coverage
8 ft.
(2.4 m)
Maximum Range
3
Red LED Indicator
ON-TIME
RANGE
MIN
MAX
TEST 1 5 OFF
MINUTES
Ball Joint
Aim Sensor Higher for
Long Coverage
70 ft.
(21 m)
Maximum
Coverage Angle
180°
Publicidad
Tabla de contenido
