Uline Shop Vac H-5814 Manual Del Usuario página 6

FILTER INSTALLATION AND MAINTENANCE CONTINUED
6. Before storing the vacuum cleaner or using for dry
pickup, clean and dry the interior of the tank and
the underside of the tank cover. Clean and allow
the filters to dry completely.
7. Wet pickup accessories should be washed
periodically, especially after picking up wet, sticky
liquids. This can be accomplished with a warm
solution of soap and water.
FOAM SLEEVE
1. With the tank cover in an
upside down position, slide the
foam sleeve down over the lid
cage, pulling until foam sleeve
completely covers the lid cage.
(See Figure 11)
BLOWER FEATURE
Your vacuum can be used as a powerful blower. To
use the blower feature, clear the hose of any debris or
obstructions.
Unscrew blower port cover located on the back of
tank cover. The blower port cover is equipped with a
retaining strap to prevent loss of the cover.
NOTE: For maximum performance when
vacuuming, remove the blower port cover.
Insert machine hose end into
blower port located on the back of
the tank cover. Twist the hose end
slightly to tighten the connection.
Caution should be used when using
as a blower due to the powerful
force of air when using certain
attachments. (See Figure 12)
WARNING! Always wear eye protection to
prevent rocks or debris from being blown or
ricocheting into the eyes or face, which can
result in serious injury.
EMPTYING LIQUID WASTE FROM THE TANK
To empty liquid waste from the tank, turn the vacuum
off and remove the plug from the wall outlet. Remove
the tank cover and deposit the liquid waste in a suitable
drain. Use side carry handles for lifting vacuum when
draining tank into drains that are located above floor
level. After tank is empty, return the tank cover to its
original position.
PAGE 6 OF 24
Figure 11
OPERATION
Figure 12
2. Place the filter retainer onto the top of the foam
sleeve. Hold the tank cover with one hand and turn
the handle on the filter retainer clockwise to lock the
filter into place.
3. To clean the foam sleeve, hold the tank cover and
turn the filter retainer counter-clockwise to loosen
and remove. Slide the foam sleeve up and off the
lid cage. Shake excess debris off of the foam sleeve
with a rapid up and down movement.
4. Hold foam sleeve under running water for a couple
minutes, rinsing from the inside of the filter. A water
wash is not always required, depending on the
condition of the filter.
5. Check the filter for tears. If any are found, replace
with a new filter.
AUTOMATIC SHUTOFF
The vacuum is equipped with an automatic suction
shutoff that operates when picking up liquids. As the
level of the liquid rises in the tank, an internal float
rises until it seats itself against a seal at the intake of
the motor, shutting off suction. When this happens, the
motor will develop a higher than normal pitch noise and
the suction is drastically reduced. If this occurs, turn unit
off immediately. Failure to turn unit off after float rises
and shuts off suction will result in extensive damage to
the motor. To continue use, empty the liquid waste from
the tank as outlined in the previous section.
NOTE: If accidentally tipped over, the vacuum
could lose suction. If this occurs, turn unit off
and place vacuum in upright position. This will
allow the float to return to its normal position
and you will be able to continue operation.
LUBRICATION
No lubrication is necessary, as the motor is equipped
with lifetime lubricated bearings.
SERVICE
Do not attempt to service your Shop-Vac® wet/dry
vacuum cleaner beyond that described in this manual.
Refer all other servicing to Uline Customer Service.
0521 IH-5814