BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
Save these instructions for local
-
inspector's use.
IMPORTANT
Observe all governing codes and
-
ordinances.
Note to Installer - Be sure to leave these
instructions with Consumer.
Note to Consumer - Keep these instructions for
future reference.
Completion Time - 1 to 3 Hours.
covered under the warranty. See Owner's Manual for
warranty information.
apply in your area. Local codes vary. Installation
electrical connections and grounding must comply
with applicable codes. In the absence of local codes,
the drawer should be installed in accordance with
edition.
WARNING
"Grounding the Appliance."
surface on the bottom of ovens, cooktops, or other
appliances.
should contact your dealer
1.800.444.1845.
1.800.561.3344.
1.800.626.2002.
MODELS AVAILABLE
30" Models: ZTW900S, ZTW900P
27" Models: ZKW700S, ZKW700P
WARNING
prevent the drawer from tipping forward when opened
and loaded. Failure to do so could result in personal injury.
2
Safety Information
CONTENTS
Design Information
Accessories ............................................................. 2
Installation Instructions : Warming Drawer
Custom Panel Accessory Kit ZXW900 .................. 9
FRONT PANEL ACCESSORIES
ZXW900
This kit provides for the installation of a custom front
panel on 30" models.
NOTE: The original drawer front will be removed and
discarded when this kit is used. The tubular handle can be
reinstalled onto the custom panel with longer screws (not
provided). Or, the original handle can be replaced with a
custom handle of your choice. (Handle is not supplied.)
Choose a custom handle to match or complement
cabinetry hardware.
For more Accessories or purchasing information please
refer to Assistance/Accessories section of Monogram
Warming Drawer Owner's Manual.
Tools and Materials Required ........................... 4
Step 1, Prepare Drawer For Panel Installation .. 9
Step 2, Remove Original Drawer Front .............. 9
Step 3, Prepare Custom Panel ........................... 9
Step 4, Secure Custom Panel to
Step 5A, For Panels Less Than 3/4" Thick ..... 10
Step 5B, For 3/4" (Or Greater) Thick Panels
Step 6, Install Lamp Jewel ................................ 10
Step 7, Reinstall Original Handle or
Step 8, Install Assembled Panel
31-2000654 Rev. 3