Link Remote Controller To Redlink™ Receiver; Exit Redlink™ Setup - Mitsubishi Electric RedLINK MHK2 Manual De Instalación

Link Remote Controller to RedLINK™ Receiver
Note: In most homes, the Remote Controller can
connect at distances of 200 feet. Try to avoid walls
or other blockages, but they should not affect
RedLINK signal.
1. Press SELECT to establish a link to the RedLINK™
receiver.
2. In less than 30 seconds, the link between the MHK2
Controller and RedLINK receiver will be established;
showing "Success" on the display.
3. Press DONE to display the home screen.
4. The MHK2 Controller will display a "WAIT" screen
while it receives data from the indoor unit. While on the
"WAIT" screen:
• If the controller shows the RedLINK™
disconnected icon
controller has lost connection with the receiver.
• If the controller shows the RedLINK™ connected
icon , the controller is connected to the receiver.
• To unenroll the receiver, press and hold the
bottom-center of the controller's screen for
5 seconds. The controller will then unenroll all
RedLINK™ connections.
Exit RedLINK™ Setup
Press and release the CONNECT button on the RedLINK™ receiver to exit wireless setup (light
should stop flashing and remain solid).
Note: The RedLINK™ Wireless Receiver will automatically exit wireless setup after 15
minutes of inactivity.
Note: If installing more than one receiver, you must exit RedLINK™ setup on the previous
receiver before attempting wireless setup of subsequent controllers/receivers.
33-00446EFS_B.indd 6
at the top-right, the
6
CONNECT RECE CONNECTING
SUCCESS
10/17/2019 3:08:59 PM