Warning Information - K Tool International XD KTI62110 Manual Del Propietário

WARNING INFORMATION

This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility
of the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are
lost or not legible, contact K-Tool International for replacements. If the operator is not fluent in English, the product and safety instructions
shall be read to and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure
that the operator comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of portable automotive lifting and support devices is subject to certain hazards that cannot be prevented by mechanical means,
but only by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the
use and operation of the equipment who are careful, competent, trained, and qualified in the safe operation of the equipment and its
proper use. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly secured loads, overloading,
off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study, understand, and follow all instructions before operating this device.
• Inspect the engine stand before each use. Do not use if damaged, altered, modified, in poor condition, or has loose or missing
hardware or components. Take corrective action before using the engine stand.
• Wear eye protection that meets ANSI Z87.1 and OSHA standards (users and bystanders).
• Do not use beyond its rated capacity.
• Use only on a hard level surface capable of supporting the load.
• Make sure all mounting hardware is securely tightened and setup is stable before rotating engine.
• Always use high strength SAE grade 8 bolts (not supplied) for mounting engine to mounting head fingers.
• Make sure widest set of mounting head fingers (if supplied) are nearest the ground when mounting engine to stand.
• Assure the load is centered, balanced and secured to the mounting head and fingers. The engine's weight should be balanced within
one inch of the mounting head's rotational axis.
• Never loosen mounting head bolts or engine mounting bolts unless engine is supported by a crane or hoist.
• Only attachments and/or adapters supplied by K-Tool International shall be used.
• Do not use stand to dolly or transport engine.
• Do not crawl under engine or place any part of your body under engine at any time.
• Refer to engine manufacturer's service manual for proper lifting points, mounting points and bolt sizes. Mounting bolts should be
torqued at appropriate amount to maintain load.
• This product may contain one or more chemicals known to the State of California to cause cancer and birth defects or other
reproductive harm. Wash hands thoroughly after handling.
• Failure to heed these warnings may result in personal injury and/or property damage.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS
SITUATIONS could cause accidents resulting in serious or fatal personal injury and/or property damage.
KTI62110
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
WARNING: Indicates a hazardous situation
WARNING
which, if not avoided, could result in death
or serious injury.
2 7/2/14