Symmons Canterbury Widespread S-264-2 Instrucciones De Instalación Y Mantenimiento página 2

Installation Instructions
Installation Instructions
If replacing an older faucet ensure water supply
Caution:
is turned before removing. Th en open faucet valves to
OFF
relieve water pressure.
Step 1 Attach control valves to sink
■ Th read fl ange nut down
about 2 inches from
threaded end of valve
body. Ensure larger
diameter end is facing up.
■ Insert valve body from
underneath sink up
through mounting hole.
Ensure valve with red
label (hot) is on the left
and blue label (cold)
is on the right.
■ Place gasket over valve
body and then thread
fastener onto valve body until stop is reached.
■ Th read collar over outer threads of
fastener until against surface of sink.
■ Tighten fl ange nut under sink to secure valve body.
Step 2 Attach faucet handles
■ Turn valve spindles to
the position.
OFF
- left valve,
HOT
clockwise
- right valve,
COLD
counter clockwise
■ Attach handle to valve
spindle in location
OFF
as shown.
■ Fasten to spindle with
Phillips head screw
and insert plug button.
Step 3 Attach faucet spout to sink
■ Unscrew tee and
remove washer
and nut from
threaded end of
spout as shipped.
■ Insert end of spout
down through
mounting hole in
sink and then fasten
from under sink
with washer and nut.
■ Tighten nut while
ensuring spout is
centered over mounting hole and
fl at edge of washer is facing rear of sink.
collar
fastener
gasket
flange nut
valve body
plug button
screw
handle
valve spindle
spout
washer
nut
tee
Step 4 Connect water supply lines
■ Apply pipe sealant
on male end of
both fl ex hoses
and thread into
sides of tee.
■ Th read center of
tee with fl ex hoses
attached onto end
of spout.
Note: Th is may
require about 4
inches of clearance
to rotate.
■ Attach loose end
of fl ex hoses to
valve outlet on
valve bodies.
■ Plumb hot water
supply to left valve
inlet, cold water to
right inlet and fasten with coupling nuts.
■ Check for leaks if only replacing faucet and drain is already
installed by fi rst turning faucet handles to the
and then turn water supply valves
Step 5 Fasten drain body to sink
■ Remove stopper, unscrew
fl ange and remove fl at
rubber washer from end
of drain body as shipped.
■ Apply plumber's putty
around bottom of fl ange.
Washer included
Note:
should only be used
when plumbers putty
is not available.
■ Move friction washer,
beveled washer and
fl ange nut down away
from threaded end
of drain body.
■ Place fl ange in drain
opening and under sink
screw drain body up into
fl ange at least
2-3
until hand tight.
■ Position drain body so pivot cavity is facing rear of sink and
then slide beveled washer and friction washer up against sink.
■ Tighten fl ange nut up against friction washer to evenly
compress beveled washer while also ensuring fl ange
is centered in drain opening.
Take care not to over tighten fl ange nut.
Page 2 Page 2
valve
body
valve
outlet
inlet
&
coupling
nut
tee
.
ON
PLUMBERS
PUT T TY
flange nut
drain body
turns
spout
flex hose
position
OFF
flange
beveled
washer
friction
washer
pivot
cavity