Publicidad
Idiomas disponibles
Idiomas disponibles
1b. Installation on Concrete
1. Using the wall plate (1) as template, making sure it's leveled, mark 4 holes at the desired location on the
wall.
2. Drill 4 3/8" (10 mm) diameter holes, 2" (50 mm) deep.
3. Insert a concrete anchor (J) into each hole, the anchors must be inserted until they are flush wish the con-
crete surface, a hammer can be used to lightly tap each anchor into place if necessary.
4. Place the wall piece back against the wall and attach it using the Lag bolts (I) and Washers (H) from the
hardware kit. Make sure all screws are snug, but do not over-tighten them.
4
Ø 3/8" (10mm)
Concrete Wall
Bubble Level
2" (50mm)
Publicidad
