Intended Use; Technical Specifications - turck RPH 2-26 Manual Del Usuario

Rotary Hammer

INTENDED USE

● This tool is intended for hammer drilling in concrete, brick and stone; for drilling in wood, metal and plastic as
well as for screwdriving (specifi c accessories should be used)
● The hammering system in this tool outperforms any traditional ratcheting drill when drilling in concrete
● This tool is designed for use in combination with all standard SDS+ accessories

TECHNICAL SPECIFICATIONS

PRODUCT ELEMENTS
1 On/Off switch
2 Switch locking button
3 Switch for changing direction of rotation
4 Switch for selecting operating mode
5 Locking sleeve
6 Auxiliary handle
SAFETY
WARNING! Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire
and/or serious injury.
● Wear ear protectors with hammer drills (exposure to noise can cause hearing loss)
● Use auxiliary handles supplied with the tool (loss of control can cause personal injury)
● Avoid damage that can be caused by screws, nails and other elements in your workpiece; remove them
before you start working
● Always keep the cord away from moving parts of the tool
● When you put away the tool, switch off the motor and ensure that all moving parts have come to a complete
standstill
● Use completely unrolled and safe extension cords with a capacity of 16 Amps (UK 13 Amps)
● In case of electrical or mechanical malfunction, immediately switch off the tool and disconnect the plug
● RONEY POWER can assure flawless functioning of the tool only when original accessories are used
● Use only accessories with an allowable speed matching at least the highest no-load speed of the tool
● This tool should not be used by people under the age of 16 years
● Be careful not to drill or drive into areas where electrical wires may be contacted
● If the cord is damaged or cut through while working, do not touch the cord, but immediately disconnect the
plug
● Never use tool when cord is damaged; have it replaced by a qualifi ed person
● Always check that the supply voltage is the same as the voltage indicated on the nameplate of the tool (tools
with a rating of 230V or 240V can also be connected to a 220V supply)
● If the drill bit becomes unexpectedly jammed (causing a sudden, dangerous reaction), immediately switch
off the tool
● Be aware of the forces that occur as a result of jamming (especially when drilling metals); always hold the
tool firmly with both hands and take a secure stance
● Always disconnect plug from power source before making any adjustment or changing any accessory
● Holding the tool
- keep the ventilation slots uncovered
- do not apply too much pressure on the tool; let the tool do the work for you
Your machine is double insulated in accordance with EN60745; therefore no earthwire is required.
MAINTENANCE
Make sure that the machine is not live when carrying out maintenance work on the motor. Regularly
5