EDM Product 08762 Manual De Instrucciones página 24

Impact drill
Operation
Before use
Remove any packing material and loose parts from unit.
Check the accessories before use. It should be fit with the
machine and your purpose.
If the machine is new, the battery must first be charged.
Attention! After long time storage, the battery capacity will
be reduce.
A new battery or one which has not been used for an
extended period achieves full performance only after
charging and discharging cycles. A substantial drop in
operating period per charge indicates that the battery is
worn out and must be replaced.
Battery charge (Fig 1)
The lithium-ion battery can be charged at any time and will
not develop a "memory" when charged after only a partial
discharge. It is not necessary to run down the battery pack
charge before recharging. Remove the battery pack from
the tool when convenient for you and your job. You can
"top-off" your battery pack's charge before starting a big job
or long period of use.
Due to lithium-ion's fade-free properties, the only time it is
necessary to charge the lithium-ion battery pack is when
the pack has reached the end of its charge. To signal the
end of charge, power to the tool will drop quickly. Charge
the battery pack as needed.
WARNING: Never use a damaged battery pack.
WARNING: Always disconnect the charger
from the power source when it is not in use.
NOTE: The battery pack and charger will become slightly
warm to the touch while charging. This is normal and does
not indicate a problem.
NOTE: If you wish to charge two battery packs in succes-
sion, unplug the charger and allow at least 15 minutes
between charges.
--The charger supplied is matched to the Li-ion battery
installed in the machine. Do not use another charger.
--This cordless drill is integrated over-charge protection,
when the battery cell was over-charge, the over-charge
protection will operate to stop charge battery.
--During the charging procedure, the battery warms up,
this is normal.
Insertion and removal of rechargeable battery (Fig.2)
Depress the battery-release button located on the battery
pack to release battery pack.
Pull the battery pack out and remove it from the tool.
Functions
a. Install the bits (Fig. 3)
When selecting a bit, use the right type for your job. For
best performance, always use sharp bits.
To open the chuck jaws, turning the sleeve in the counter-
clockwise direction.
Insert the bit deeply into the chuck, and then center the
bit in the chuck jaws.
To close the chuck jaws, turning the sleeve in the clockwise
direction as far as possible until the bit gets locked securely.
INSTRUCTION MANUAL
EN
Fig. 3
Tighten Open
b. Torque adjustment (Fig. 4)
Select the desired operating torque by turning the ring to
the appropriate setting and adjust the drilling position
Fig. 4
Torque
Torque
down
up
c. Forward/Reverse adjustment (Fig. 5)
The forward/reverse switch enables you to change the
rotation movement of the chuck, and also acts as a lock
button. For forward rotation, release trigger switch, and
then depress reverse switch to left handle side, press switch
to right hand side for reverse rotation, the centre position
locks the drill to off. Always release the trigger switch when
changing rotation. Note the first time you use the drill after
changing rotation, you may hear a click when the drill is
turned on, and this is normal and does not indicate a
problem.
WARNING: Never change the forward/reverse switch while
the drill is rotating as this damage the drill.
Fig. 5
Forward
Fig. 6
REF. 08762
Reverse