Black and Decker Piranha Manual De Instrucciones página 5

This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and the receiver.
. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
ASSEMBLY INSTRUCTIONS
INSTALLING AND REMOVING THE BATTERY PACK FROM THE TOOL
WARNING:
Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery
pack into tool, until an audible click is heard
as shown in figure B.
TO REMOVE BATTERY PACK: Depress the
battery release buttons as shown in figure C
and pull battery pack out of tool.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
OPERATING INSTRUCTIONS
WARNING: Always wear proper eye, respiratory and hearing protection while
operating this tool.
• Use clamps or another practical way
to secure and support the workpiece
to a stable platform. Holding the work
by hand or against your body leaves it
unstable and may lead to loss of control.
• Place shoe firmly against work to be cut.
• Hold the tool with one hand as shown in
figure D. Switch on saw motor and allow
it to obtain maximum speed before
applying pressure.
TRIGGER SWITCH (FIGURE E)
The tool is equipped with a switch lock-off feature to prevent unintentional operation.
• To switch the tool on, press the lock off
button (4) as shown in figure E, then
squeeze the on/off switch (3).
• Once the tool is on, release the lock off
button.
• Releasing the trigger turns the motor OFF.
NOTE: This tool has no provision to lock
the switch in the ON position, and should
never be locked in the ON position by any
other means.
B
C
D
E
4
3
8
USING THE CLAW (FIGURE F)
To release claw (7):
• Pull back on claw release button (5). This
will release the claw. Once claw is
released you can let go of button.
• Push in on lock-off button (4) and
squeeze the on/off switch (3).
• With the saw running, the claw will rotate
forward until it comes in contact with the
workpiece.
• Once the cut is complete, the claw will
rotate fully back to the stop position.
BLADE INSTALLATION AND REMOVAL (FIGURE G)
CAUTION: Make sure the lock-off button is engaged to prevent switch actuation
before making any adjustments or removing or installing attachments or accessories.
The blade should extend past the shoe and the thickness of the workpiece during the
cut. Select the blade best suitable for the material to be cut and use the shortest blade
suitable for the thickness of the material.
WARNING: Cut hazard. Blade breakage may occur if the blade does not extend past
the shoe and the workpiece during the cut. Increased risk of personal injury, as well as
damage to the shoe and workpiece may result.
TO INSTALL BLADE INTO SAW
1. Point tool away from body.
2. Rotate blade clamp release lever (8) in the
direction shown in figure G.
3. Insert blade shank fully into blade clamp.
4. Release blade clamp release lever (8) to
lock blade into position.
TO REMOVE BLADE FROM SAW
WARNING: Burn hazard. Do not touch
the blade immediately after use. Contact with
the blade may result in personal injury.
1. Rotate blade clamp release lever (8) in the
direction shown in figure G.
2. Remove blade.
3. Release the blade clamp release lever (8).
F
5
4
3
7
G
8
9