Publicidad
Idiomas disponibles
Idiomas disponibles
KIT PREPARATION
1. Attach the clock/hazard housing to the
radio trim panel using (6) #4 x 3/8"
Phillips pan-head screws provided.
WARNING: DO NOT OVERTIGHTEN
THE SCREWS.
2. Clip the clock/hazard assembly into the
radio trim panel. (Figure A)
3. Attach (4) factory panel clips to the
radio trim panel. The middle clip will
not be reused to allow room for the
larger aftermarket radio.
Note: (4) panel clips have been
provided, only if the factory clips are
missing or damaged.
4. Cut the factory dash panel in areas
indicted to allow room for the
aftermarket radio. (Figure B)
Continue to Kit Assembly
Insert Clock/Hazard switch assembly from
rear of 108-TO2 radio housing trim panel
(Figure A)
Remove shaded area
(Figure B)
KIT ASSEMBLY
Note: For steps 1 and 2, reference the
installation manual provided with the radio
for which hardware to use. The display
screen and radio chassis use two different
types of screws.
1. Secure the radio brackets to the radio
chassis using (4) screws supplied with
the radio. (Figure A)
2. Secure the radio display to the radio
brackets using (4) screws supplied with
the radio. (Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
4. Slide the completed radio assembly into
the dash, then secure it using the factory
screws.
5. Re-connect the clock/hazard assembly
back to the vehicle, then clip the radio
trim panel over the radio assembly.
6. Reassemble the dash in reverse order of
disassembly to complete the installation.
(Figure A)
(Figure B)
REV. 8/29/2019 INST108-TO2
3
Publicidad
