Publicidad
Idiomas disponibles
Idiomas disponibles
Panel Section Assembly
7
Your kit contains two rails. One rail has two sets of
slots for the pickets on the upper and lower edges.
The other rail has one set of slots on only one edge.
Assembling Style 1 (Pool Style Fence)
NOTE:
For this style, use the rail with two sets of slots for
the bottom rail. Use the rail with one set of slots
for the top rail, with slots facing down. Style 1 will
also utilize the 1
a.
Insert the 1
a stop for the pickets (Fig. 10).
b.
Place the brackets from the Slidelock™ Bracket
Kit inside both ends of the bottom and top rails
until ush. If needed, tap with rubber mallet (Fig. 11).
c.
Assemble the panel section by inserting the
pickets into both top and bottom rails (Bottom
ends of pickets have lock tabs. Do not remove
lock tabs) (Fig. 12).
d.
Lower the panel assembly down between the
posts and secure onto dovetails on both posts
(Fig. 13).
e.
Repeat steps until all fence panels and posts have
been installed.
6
⁄
⁄
⁄
⁄ " Picket.
1
1
1
2
2
⁄
⁄
⁄
⁄ " picket into the bottom rail, to act as
1
1
1
2
2
Pool Style "Bottom Rail"
Pool Style "Bottom Rail"
1
⁄ " Picket "Stop"
⁄
⁄
⁄
1
1
1
2
2
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Publicidad
