Attaching Handle - Uline H-3594 Instrucciones De Ensamblaje

Figure 8

ATTACHING HANDLE

1. Place the locking door handle (11) on the right hand
door and fasten with two slotted bolts and lock
washers. (See Figure 8)
2. Turn the handle to the open position (See Figure 9)
and place the locking cam (15) over the square
shank of the door handle. Place the cotter pin (12)
through the hole of the square shank.
(See Figure 10)
3. With the handle still in the open position, hook the
lock bars (14) into the locking cam (15). Once in
position, slowly rotate the door handle to the closed
position so the lock bars protrude from the holes at
the top and bottom of the door. (See Figure 11)
4. Slide the nylon lock bar guides (13) over the lock
bar (14) ends and through the door slots. Push firmly
until the guides snap into place. If necessary, turn
the handle back to the open position and gently
tap with a hammer until the guides snap into place.
(See Figure 12)
5. Attach dummy handle (11) to the left door using two
slotted bolts and lock washers.
Open Position
Open Position
Figure 9
PAGE 5 OF 15
ASSEMBLY CONTINUED
11
Closed Position
Closed Position
1-800-295-5510
Figure 10
Figure 11
14
14
15
15
14
14
uline.com
12
15
Figure 12
0221 IH-3594
13
13
13
13