Installation (continued)
3
Threading the wire
□ Thread the wire (BB) through the eyelet of one D-ring to the
opposite D-ring and back to the beginning point.
□ Cut any excess wire (BB) and knot it to secure to the eyelet
of the D-ring.
□ Cover the sharp edges with electrical tape.
Loose lark's head shows
pattern of threading
Pull knot tight
Twist loose end into tight
and wrap snug against
knot
4
Hanging the mirror
□ Measure 6 in down from the top mark on the wall and 12 in
right from the same mark.
□ Make sure the mirror (A) is at least 1 in. above the faucet.
□ Drill a pilot hole. This will be used to anchor a wood screw
(AA) to hang the mirror (A).
□ Hang the mirror (A) by the metal wire (BB).
6
For questions, contact customer service at 1-800-986-3460 for assistance
HOMEDEPOT.COM/HOMEDECORATORS