Worx WX852L Manual De Instrucciones página 3

immediately with soap and water. If acid enters
eye, immediately flood eye with running cold
water for at least 10 minutes and get medical
attention immediately.
e. NEVER smoke or allow a spark or flame in
vicinity of battery or engine.
f. Be extra cautious to reduce risk of dropping a
metal tool onto battery. It might spark or short-
circuit battery or other electrical part that may
cause explosion.
g. Remove personal metal items such as rings,
bracelets, necklaces, and watches when working
with a lead-acid battery. A lead-acid battery can
produce a short-circuit current high enough to
weld a ring or the like to metal, causing a severe
burn.
12. When charging the internal battery, work in a well
ventilated area and do not restrict ventilation in
any way.
13. Under abusive conditions, liquid may be ejected
from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid
contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause
irritation or burns.
14. Do not expose a power pack to fire or excessive
temperature. Exposure to fire or temperature
above 130°C may cause explosion. The
temperature of 130°C can be replaced by the
temperature of 265°F .
15. Have servicing performed by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the product is
maintained.
16. Attach output cables to a battery and chassis as
indicated below. Never allow the output clamps
to touch one another.
a. Instructions shall include step by step
directions for the proper use of the booster
function detailing the correct steps to connect and
disconnect the booster cables to the battery.
b. Each step shall be a different numbered item.
SAVE THESE INSTRUCTIONS
ADDITIONAL SAFETY
INSTRUCTIONS FOR JUMP
STARTER
Warning- When using flashlight or lanterns,
additional precautions should always be
followed including the following:
1. To reduce the risk of injury, close supervision is
necessary when a product is used near children.
2. Do not contact hot parts.
3. Only use attachments recommended or sold by
the manufacturer.
4. Do not use the unit for works other than those for
which they are designed.
5. Do not disassemble the unit and keep it out of the
reach of children.
6. Do not use in the rain or get wet.
7. Warning: to reduce the risk of injury, do not stare
12V Multifunction Jump Starter with LED
Lights
at operating lamp. Serious eye injury could occur.
8. Warning: Do not use magnet for horizontal
overhead mounting.
9. Warning: The lens get very hot during use. To
reduce the risk of burns, do not touch hot lens.
10. To reduce the risk of fire, keep away from
combustible materials while in operation.
11. Do not short out the contacts of jump starter.
12. Do not charge the jump starter with a damaged
wall charger or power extension cord. Replace
them immediately.
13. When using, ensure that the product is in a
well-ventilated area and away from inflammable
materials.
14. Batteries can get hot during charging. Do not
overcharge any batteries. Ensure that Jump
Starter are not left unsupervised during charging.
15. Protect the product away from fire and heat, such
as sunlight.
16. Please use the specified charger (cable) for
charging. If the product or cable is damaged,
please do not use the product.
17 . Do not disassemble, bump, squeeze, puncture or
penetrate the product.
18. Keep jump starter dry, clean and oil-free. Be sure
to use a clean cloth when cleaning and do not use
any corrosive solvent.
19. Longer life and better performance can be
obtained if the battery is charged when the air
temperature is between 18°C and 24°C. Do not
charge the battery in air temperatures below 0°C,
or above 40°C. This is important as it can prevent
serious damage to the battery.
20. Do not recharge non-rechargeable batteries, as
they can overheat and break.
21. Risk of electric shock and fire. This device cannot
be stored at a high temperature, especially not in
the vehicle with high temperature.
ADDITIONAL SAFETY
INSTRUCTIONS FOR USING
AS JUMP STARTER
WARNING: The jump starter should only be
used as a jump starter with the supplied Safety
Cable. NEVER use an alternate cable when
jump starting with the jump starter.
1. Someone should always be within range of your
voice or close enough to come to your aid when
you work near a lead-acid battery.
2. Have plenty of fresh water and soap nearby in
case battery acid contacts skin, clothing or eyes.
Protective eyewear should always be worn when
working near lead-acid batteries.
3. If battery acid contacts skin or clothing, wash
immediately with soap and water. If acid enters
eye, immediately flood eye with running cold
water for at least 10 minutes and get medical
attention immediately.
4. Be extra cautious to reduce risk of dropping a
metal tool onto a battery. It might spark or short
circuit the battery or another electrical part that
3
EN