Pentair Link2Oñ Guia De Inicio Rapido

GATEWAY
TM
NOTICE: Please create an account on www.mylink2o.com before installing the gateway.
1
If the gateway was installed prior to creating an account, please unplug the gateway and
connected Link O device from its power source and wait 30 seconds. After the 30
TM
2
seconds, restore power to the gateway.
What's in the bag
Gateway
Power Adapter
Cat5e Cable
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
293 WRIGHT STREET, DELAVAN, WI 53115 WWW.PUMPS. COM
PH: 1-866-9 PENTEK ORDERS FAX: 800-426-9446
© 2017 Pentair plc. All Rights Reserved.
Plug in and hook up the gateway
Hook up Cat5e cable between gateway and router.
2
Plug the adapter into the gateway
3
and a standard outlet.
Quick Start Guide
PN1043 (09/06/17)