Kohler K-1114 Diagrama De Instalación página 2

21"
(53.3 cm)
3-3/4"
(9.5 cm)
1-1/4"
(3.2 cm)
3-1/2"
(8.9 cm)
Product Information
Applicable product:
Integral apron, heater, left
drain
Integral apron, heater, right
drain
Fixture*: basin area
Bathing well 55" (139.7 cm) x
23-1/4" (59.1
cm)
water depth
To overflow 15" (38.1 cm)
* Approximate measurements for comparison only.
Pump: Hp
1-speed 1.25
Heater: kW
1.5
1047192-1-B
11-1/16" (28.1 cm)
72" (182.9 cm)
3/8" (1 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
K-1114-HL shown
K-1114-HR not shown
top area
64" (162.6 cm) x
32" (81.3 cm)
capacity
78.5 gal (297 L)
V Hz
120 60
V Hz
120 60
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
1-1/4" (3.2 cm)
21" (53.3 cm)
Required Electrical Service (2 required)
Two dedicated circuits required, each protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
Heater
Locate the outlets behind the whirlpool and within 24" (61 cm)
of the pump and heater.
weight
Notes
149 lbs
(68 kg)
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of 80
lbs./square foot (390 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no interference
with the drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
A
This fixture conforms to ANSI Standard Z124.1. All dimensions are
7.5
nominal.
A
12.5
2
Recommended faucet area
1-1/4"
(3.2 cm)
Tile Flange
Detail
42" (106.7 cm)
1-1/2" OD
120 V, 15 A, 60 Hz
120 V, 15 A, 60 Hz
Kohler Co.