Hikmicro B Serie Guia De Inicio Rapido página 6

Transportation
● Keep the device in original or similar packaging while transporting it.
● Keep all wrappers after unpacking them for future use. In case of any failure occurred, you need to return the
device to the factory with the original wrapper. Transportation without the original wrapper may result in
damage on the device and the company shall not take any responsibilities.
● Do not drop the product or subject it to physical shock. Keep the device away from magnetic interference.
Power Supply
● The input voltage should meet the Limited Power Source (3.7 VDC, 0.4 A) according to the IEC61010-1
standard. Please refer to technical specifications for detailed information.
● Make sure the plug is properly connected to the power socket.
● DO NOT connect multiple devices to one power adapter, to avoid over-heating or fire hazards caused by
overload.
Battery
● The built-in battery cannot be dismantled. Please contact the manufacture for repair if necessary. The battery
may explode if it is replaced by an incorrect type. Replace with the same or equivalent type only. Dispose of
used batteries in conformance with the instructions provided by the battery manufacturer.
● For long-term storage of the battery, make sure it is fully charged every half year to ensure the battery quality.
Otherwise, damage may occur.
● Make sure the plug is properly connected to the power socket.
Maintenance
● If the product does not work properly, please contact your dealer or the nearest service center. We shall not
assume any responsibility for problems caused by unauthorized repair or maintenance.
● Wipe the device gently with a clean cloth and a small quantity of ethanol, if necessary.
● If the equipment is used in a manner not specified by the manufacturer, the protection provided by the
device may be impaired.
Using Environment
● Make sure the running environment meets the requirement of the device. The operating temperature shall
be -10°C to 50°C (14°F to 122°F), humidity shall be 90% or less, and height ≤5000 m.
● Place the device in a dry and well-ventilated environment.
● DO NOT expose the device to high electromagnetic radiation or dusty environments.
● DO NOT aim the lens at the sun or any other bright light.
● When any laser equipment is in use, make sure that the device lens is not exposed to the laser beam, or it
may burn out.
Emergency
● If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the power cable, and
contact the service center.
Manufacture Address
Room 313, Unit B, Building 2, 399 Danfeng Road, Xixing Subdistrict,Binjiang District, Hangzhou, Zhejiang 310052,
China
Hangzhou Microimage Software Co., Ltd.
4