Prestige MEDICAL HM-30 Manual De Instrucciones página 14

HOW TO MEASURE
b. Recalling data:
(1) Press MEM button. No reading will
appear on the display if there is no
data in the memory. If there is data
in the memory, the latest recorded
sets of measurements (systolic
pressure, diastolic pressure,
and pulse rate) will appear on the
display for one minute.
(2) Press MEM button to read the next
line of stored data. The data called
up on the display is numbered
accordingly.
(3) To stop reading from the memory,
press START/STOP button.
c. Erasing data:
(1) Take out the batteries and then put them back.
(2) To check if the data is erased, press MEM button, no
data should show up on the screen.
4. Changing batteries:
When battery low symbol
the battery is weak. Take out all four batteries and put in 4
new "AA" Alkaline batteries.
*Attention!
-All batteries used must be the same type. Do not mix alkaline,
standard (carbon-zinc) or rechargeable (cadmium) batteries.
-Do not mix old and new batteries.
-When you change the batteries, all stored data will disappear.
shows up on the display,
13
mmHg
mmHg