LG LWP-277 Serie Instrucciones De La Instalación página 3

Level the washer/combo on the pedestal by
adjusting the feet.
Lock nut
Adjustable feet
Make sure the holes on the pedestal align with the
holes in the appliance, then install 4 screws at each
corner to securely attach the appliance to the pedestal.
NOTE
If the screws are not installed properly, noise and
vibration may result.
For WASHER: 16 SCREWS
For DRYER: 8 SCREWS
Adjustable feet
3
Move the washer/combo to the desired place.
NOTE
The appliance and pedestal assembly must be placed
on a solid and level floor for proper operation. Adjust
the legs of the appliance and pedestal by turning with
a wrench. Then, adjust the lock nut toward the
pedestal while holding the pedestal leg using a
wrench.
Lock nut
Adjustable feet
NOTE
Diagonal Check
When pushing down the edges of
the washing machine top plate
diagonally, the machine should not
move up and down at all.(Please
check both directions.) If the
machine rocks when pushing the
machine top plate diagonally, adjust
the feet again.
NOTE
To make sure that the washer is properly level, run
the washer with a test load: place approximately
6 Pound/2.7Kg of laundry in the machine. Then press
POWER, press RINSE+SPIN, and then press the
START/PAUSE button. See the following sections for
additional information on cycle selection and
operation. Verify that the washer does not rock or
vibrate excessively during the spin cycle. If the washer
vibrates or shakes, adjust the leveling feet until the
washer is stable and retest.
Adjustable feet