English; Care And Maintenance - Roto ZRS M Manual De Instrucciones

English

General safety instructions
• Read this manual carefully before installing and operating
the device and follow all instructions.
• Ensure that this manual is accessible to all users.
• Keep this manual in a safe place until you dispose of the
product.
• If the product changes hands, pass this manual on to the
new owner.
Intended use
The "Standard" roller blind is intended for inside installation
and protects against heat and sunlight.
It may only be installed and used on Roto skylight types de-
signed for its use.
The "Standard" roller blind reflects and absorbs a large por-
tion of solar radiation, but does not offer full protection
against sunlight and heat (in a physical sense).
Unpacking/checking the scope of delivery
(Fig. A1)
⚠
Risk of suffocation!
Plastic parts, polystyrene, screws, small parts,
etc., can be very dangerous for children to play
with.
> Do not leave the packaging material and installation
parts lying around, and keep away from children and
toddlers.
> Keep children away from the installation site throug-
hout the installation procedure.
• Please dispose of the packaging material (cardboard, polysty-
rene, plastic bag) according to local regulations.
• When unpacking and installing the device, work with clean
hands or with gloves to avoid soiling the product.
• Please check the scope of delivery. If parts are missing,
consult a dealer.
Preparing tools/aids
(Fig. A2)
• Pencil
• Cross-head screwdriver, PZ1
• Slotted screwdriver
• Tape measure/yardstick
• If needed: stable climbing equipment (step ladder)
Installation
(Fig. 1-5)
⚠
Risk of falling!
> Only use climbing equipment that is resting on a solid
foundation and that offers good support and high car-
rying capacity.
> Do not lean out of the skylight.
6
⚠
Risk of injury from falling components!
> To mount the product, only use fixing materials that
were included in the delivery and that are suitable for
the window frame material.
> Never place tools, components and fixing materials on
the climbing equipment.
> Keep children away from the installation site throug-
hout the installation procedure.
Settings
(no figure)
Settings are not required after installation.
Operation
Closing the roller blind
(Fig. 6)
• Grasp the roller blind by the centre of the handle, pull down
and hook into the desired hooks on both sides.
Opening the roller blind
(Fig. 7)
• Grasp the roller blind by the centre of the handle, unhook
from the hooks on both sides and push up.

Care and maintenance

Care
(no figure)
To ensure a long life, we recommend cleaning the aluminium
surface of the product at least once a year.
• Wipe the aluminium surface with a moist cloth only.
• Carefully brush off the roller blind fabric.
Retightening the spring mechanism
(Fig. B1-B4, back of the manual)
The spring mechanism can lose its tension after extended
use, preventing the roller blind from functioning properly.
If the roller blind fabric winds up without tension when
opened, the spring mechanism should be retightened.
• Open the roller blind.
• Open the window to the cleaning position.
• Pull the roller blind fabric up slightly and let it roll up until it
locks.
• Close the window.
• Pry the roller blind holder out of the bracket with a scre-
wdriver and remove it.
• Retighten the spring mechanism.
• Reinstall the roller blind holder.