GE 29884-PK1 Manual De Usuario página 15

If you are using a pre-built cable that has connectors,
follow these steps.
i. Cut 4 slits spaced evenly apart at the narrow tip of the
provided Rubber Boot approximately ¼" in length.
(Fig. 6c)
ii. Run the coax cable through the narrow end of
the Rubber Boot and attach the cable to the
antenna.
iii. Slide the Rubber Boot into the round channel on
the Main Housing Unit.
iv. Using the Small Zip Tie, wrap the tie around the
narrow tip of the Rubber Boot, around the four
slits and pull the tie tight.
Use a second coax cable and connect one end to
mating port of the first coax cable on the 75 ohm
grounding block and run the other end into your home
for making the connection to your TV. The 75 ohm
grounding block needs to be placed as close as
possible to the point where the second coax cable enters
your home
Note: Leave enough slack in the coax cable to create a
drip loop so that moisture cannot enter the house. You
will also need to seal the coax cable entry point into
your house with an exterior caulk.
Fig. 6c
15