Installation Tips - Roca SMART SHOWER A5A104AC00 Manual De Instrucciones

❚

INSTALLATION TIPS

• On page 25 different installation schemes are shown depending on the number of outputs
applied.
• It is recommended to install the mixer, the power supply, the electrical connection and the
WIFI/BT module of the SMART SHOWER in volume 3 of the shower environment according
to the figure on page 26, according to current regulations (false ceiling for example).
• The mixer must be installed in an accessible place to perform maintenance.
• The mixer and panel must be installed according to the drawings below.
• It is recommended to install stopcocks upstream of the Mixer Box to facilitate maintenance.
• DO NOT weld accessory pipes less than 300 mm from the SMART SHOWER mixer.
• DO NOT install any type of shutter valve downstream of the mixer outlets.
• DO NOT force or collapse the flexible hoses with the connections to the SMART SHOWER
mixer.
• The filters and non­return valves must be installed in the cold and hot water inlets, included
in the product.
• Purge the pipes before installing the mixer and the selected outlet fittings. See instalation
guidelines on page 27.
• When the installation is finished, you must check that all connections are tight.
• The cables embedded in the walls must be protected with corrugated pipes to allow main­
tenance or elimination of the service.
• This device is designed to be permanently connected to the fixed wiring of the mains sys­
tem.
• Make sure all electrical connections are properly tightened to prevent overheating.
• Use only the power supply only to connect the SMART SHOWER. Do not connect other
equipment to the same power supply.
• Check that good WIFI/BT coverage is available within the shower space. Otherwise, impro­
ve said coverage to be able to use the App satisfactorily.
• The factory setting enables only one output. The "Start up" program must be run once the
system is fully installed to enable additional outputs.
23