Lithium Earthwise LST02212 Manual Del Operador página 3

UNPACKING
This product requires some assembly.
PACKING LIST
String Trimmer - Safety Guard
Charger and Battery Pack—Instruction Manual
Hardware Pkg. (attached to Safety Guard)
WARNING: Do not install battery until assembly is complete.
Failure to comply could result in accidental starting and
possible serious personal injury.
WARNING: If any parts are damaged or missing do not oper-
ate this product until the parts are replaced. Failure to heed
this warning could result in serious personal injury.
Carefully remove the product and any accessories from the
box. Make sure that all items listed in the packing list are in-
cluded. Inspect the product carefully to make sure no break-
age or damage occurred during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call 1-500-313-
5111 for assistance.
ATTACHING THE GUARD
Assemble the guard as shown below by sliding it over the
head of the motor housing and rotating it counter clockwise.
Using a Phillips screw driver, secure the four (4) screws into
the guard and motor housing. Remove blade guard before
use.
WARNING: Do not operate the trimmer without the guard
attached.
TO TURN THE TOOL ON
Push the lock button in with your thumb and then squeeze the
trigger with your fingers. (Once the tool is running, you can
release the lock button). To turn the tool OFF, release the
trigger.
Before you start the unit, make sure the trimmer is not contact-
ing any object.
WARNING: Stones, pieces of metal and other objects can be
thrown out at high speed by the line. The unit and guard are
designed to reduce the danger.
ASSEMBLY
AUXILIARY HANDLE ADJUSTMENT
For maximum comfort and control, adjust the auxiliary handle to suit
your height. Shorter users adjust handle to a lower position (away from
you) and taller users adjust handle to an upper position (towards you).
The handle should be adjusted so that your front arm is straight.
HEIGHT ADJUSTMENT
The overall height of the trimmer can be adjusted by loosening the
locking collar. The tubes can then be extended shorter or longer.
When the desired height is achieved rotate the locking collar back to the
original tightened position.
CUTTING WIDTH ADJUSTMENT
Cutting width can be adjusted to 10" or 12" by positioning the line cutting
blade as shown.
Blade Guard
OPERATING
WARNING: To guard against injury, observe the following:
If you strike or become entangled with a foreign object, stop
tool immediately, check for damage and have any damage
repaired before further operation is attempted. Do not operate
with a broken hub or spool.
3
Position on inside
position for 10"cut

Read instruction manual before using, save
instruction manual.

Keep hands away from lines.

Keep hands on handles. Don't overreach.
Position on outside
position for 12"cut